FreeTronics 4x4x4 no response - upload fine

The "Cube4" is a 4x4x4 RGB LED cube with an Arduino Leonardo compatible onboard controller. [Product page]
Joined:Tue Dec 18, 2018 5:52 pm
FreeTronics 4x4x4 no response - upload fine

Post by cowboybilliards » Tue Dec 18, 2018 5:54 pm


Here is the setup I currently have. I have gotten past the Error 1 issue.

The following is under a directory called Arduino:

Under a Folder in ARDUINO, I have

cube4 > cube4 - master

hardware > FreeTronix USB Drivers

Leonardo Drivers


Is this correct? What am I missing....I am running win 10 and went back from IDE 1.8.8 to 1.0.6 thinking IDE is not backward compatible.....

I seem to be able to upload as the Verify/Upload comes out clean, but I only get rapid blue light, some movement of the LEDs: a slight flash, and that is it....

Any ideas?



P.S. did not see a related post.

Post Reply