Servo wires

The Experimenters Kit includes an "Eleven" Arduino-compatible board, plus a range of parts and a guide to make it easy to get started with Arduino projects. [Product Page]
Post Reply
Joined:Wed Sep 10, 2014 11:32 am
Servo wires

Post by kellyw » Wed Sep 10, 2014 11:40 am


Just bought a new Experimenters Kit.
According to project guide, Servo for project 6 should have 3 separate wires which are to connected to GND, 5V and D11. But the Servo provided with my kit has 3 connected wires with single 3 pin female connector. How do I connect this to the Arduino?

Cheers Wayne.

Freetronics Staff
Freetronics Staff
Joined:Tue Apr 09, 2013 11:19 pm
Location:Melbourne, Australia

Re: Servo wires

Post by angusgr » Wed Sep 10, 2014 10:23 pm

Hi Wayne,

You can use the male-to-male breadboard wires with the servo socket. If you insert a wire into each of the 3 female connections on the servo, you can then run the other ends to the female connections on the Eleven.



Post Reply