I have various debug outputs printed to the serial port but I've noticed after a while that they stop - I can see the board is still running as I can see it sending data via Wireshark and the USB Tx LED flashes.
I've noticed this using the Arduino IDE's built-in Serial Monitor and also using Cornflake (Mac serial terminal program).
I've got a DHT22 temp. sensor connected to pin 2, and LEDs connected to pins 3/5/6/7/8/9/11/12
Has anyone else seen this?
Combining the power of the ATmega2560 MCU with onboard Ethernet, a microSD card slot, an efficient switchmode power supply, and a small prototyping area. [Product page]
1 post • Page 1 of 1