EtherTen PoE

The EtherTen combines an Uno-equivalent Arduino-compatible board and Wiznet-based Ethernet support, along with a microSD card slot and Power-over-Ethernet support. [Product page]
Post Reply
Nivin37
Posts: 4
Joined: Wed Nov 23, 2011 10:33 am

EtherTen PoE

Post by Nivin37 » Mon Sep 23, 2019 11:35 am

Hi,
Purchased & installed two(2) PoE daughterboard's.

One is running as I expect no issue and running with very little heat.

The second is running very hot and keeps getting hotter and hotter until I shut it down after reaching an internal temp of 50+ deg C .

I have tried several different sketches, all the same result. Currently running a sketch that just reports the internal temp.

Any ideas as too what may be the issue, I have checked the voltages on the board, all look to be correct.

Anyone experienced anything like this before?

If I get no good leads I will move it to another EtherTen.

Thanks in advance.

Steve...

Brissieboy
Posts: 177
Joined: Fri Sep 20, 2013 7:25 am

Re: EtherTen PoE

Post by Brissieboy » Mon Sep 23, 2019 10:20 pm

You do not provide enough details to allow people to offer much help.
- no idea what PoE board you are using
- no idea of what is actually getting hot
- no idea of how you have them set up
- does the problem stay with the PoE board if you swap them over?
- have you double-checked all your wiring?
- have you double-checked voltages?
- have you checked the current being drawn?

Post Reply