Here is the setup I currently have. I have gotten past the Error 1 issue.
The following is under a directory called Arduino:
Under a Folder in ARDUINO, I have
cube4 > cube4 - master
hardware > FreeTronix USB Drivers
Is this correct? What am I missing....I am running win 10 and went back from IDE 1.8.8 to 1.0.6 thinking IDE is not backward compatible.....
I seem to be able to upload as the Verify/Upload comes out clean, but I only get rapid blue light, some movement of the LEDs: a slight flash, and that is it....
P.S. did not see a related post.
The "Cube4" is a 4x4x4 RGB LED cube with an Arduino Leonardo compatible onboard controller. [Product page]
1 post • Page 1 of 1