Hi,
Just bought a new Experimenters Kit.
According to project guide, Servo for project 6 should have 3 separate wires which are to connected to GND, 5V and D11. But the Servo provided with my kit has 3 connected wires with single 3 pin female connector. How do I connect this to the Arduino?
Cheers Wayne.
Servo wires
-
- Freetronics Staff
- Posts:853
- Joined:Tue Apr 09, 2013 11:19 pm
- Location:Melbourne, Australia
- Contact:
Re: Servo wires
Hi Wayne,
You can use the male-to-male breadboard wires with the servo socket. If you insert a wire into each of the 3 female connections on the servo, you can then run the other ends to the female connections on the Eleven.
Regards,
Angus
You can use the male-to-male breadboard wires with the servo socket. If you insert a wire into each of the 3 female connections on the servo, you can then run the other ends to the female connections on the Eleven.
Regards,
Angus