I love the ether mega but it is a right royal pain trying to get many shields working with it because of the ethernet socket.
In particular the range of mega sensor shields out there have to have a double row of headers added to ensure the board clears the ethernet jack - this is OK for the digital and analog side pins - however i am yet to find a set of headers for the double row of pins at the end of the board. Trying to "make" a set does not work as they do not line up correctly.
The only workable solution i have found so far is to use a right angle male/female header combo from a PCB to enable me to bring these pins out - i do however then not have them represented on the Sensor shields/proto shields
I think this is something sorely needed to enable clearance of the ethernet jack.
Combining the power of the ATmega2560 MCU with onboard Ethernet, a microSD card slot, an efficient switchmode power supply, and a small prototyping area. [Product page]
1 post • Page 1 of 1