Need assistance from the gurus

Just want to hang out with other Makers and chat about stuff? This is the place to do it.
Post Reply
keiranwyllie
Posts: 40
Joined: Tue Aug 16, 2016 9:17 am

Need assistance from the gurus

Post by keiranwyllie » Wed Sep 21, 2016 12:10 pm

Hi all,

Can someone give me an idea whether I'm on the right path with my circuit. It's an LED tactile switch from Jaycar. My signal line is connected to a digital pin on an EtherTen and I have programmed as an INPUT. When pressed, the signal line goes to 5V.

Just after some feedback if possible. I'm having a couple of issues and wanted to eliminate the switch circuit if I can .

Image
Top
keiranwyllie
Posts: 40
Joined: Tue Aug 16, 2016 9:17 am

Re: Need assistance from the gurus

Post by keiranwyllie » Thu Sep 29, 2016 7:53 am

Can no one provide any thoughts or input?
Top
danieldewaard
Freetronics Staff
Freetronics Staff
Posts: 33
Joined: Thu Jul 14, 2016 2:41 am

Re: Need assistance from the gurus

Post by danieldewaard » Mon Nov 07, 2016 12:35 pm

Hi Keiran,

Could you be more specific about what sort of issues you were having?
Top
KegRaider
Posts: 15
Joined: Sun Sep 09, 2012 12:08 am

Re: Need assistance from the gurus

Post by KegRaider » Thu Dec 08, 2016 9:31 pm

Hi Keiran,

To eliminate the switch being the problem, why not just use a breadboard wire as the switch? I do most of my fiddling on breadboards, with short pieces of wires. I only put a physical switch in place after my initial testing, and just prior to installing perminently.

Good luck, happy troubleshooting :)
Attachments
1.jpg
Top
Post Reply

Return to “Random Chit-Chat”