Load Sketch via Ethernet

Just want to hang out with other Makers and chat about stuff? This is the place to do it.
Post Reply
JamesBrown
Posts: 7
Joined: Fri Apr 12, 2013 6:27 pm

Load Sketch via Ethernet

Post by JamesBrown » Fri Sep 27, 2013 7:25 pm

Is it possible to load a sketch using the ethernet rather than the serial port?
Has there been any advance on push/pull updating over the net?

angusgr
Freetronics Staff
Freetronics Staff
Posts: 853
Joined: Tue Apr 09, 2013 11:19 pm
Location: Melbourne, Australia
Contact:

Re: Load Sketch via Ethernet

Post by angusgr » Sun Sep 29, 2013 9:31 pm

Hi JB,

Yes, this is absolutely possible. There's a guide to doing it on an EtherTen, here: http://www.freetronics.com/pages/how-to ... kibf6zDTRY

It should also be possible on an EtherMega, I gave some pointers in this thread the other day:
viewtopic.php?f=25&t=5496

With regards to "push/pull", the first article also links to the arduino-netboot firmware which should be able to update itself any time it resets. Is that what you mean?

Regards,


Angus

Post Reply