New Docs please...

The USBDroid provides USB Host functionality for use as an Android peripheral as an Open Android Development Kit board. [Product page]
Post Reply
davewal
Posts: 11
Joined: Sat Mar 24, 2012 11:58 pm

New Docs please...

Post by davewal » Sun Aug 05, 2012 1:07 am

Just setting up my USBDroid, and the docs say (point 6) it's ready shipped with the 'blink' application.
When I plugged it in, no blinkin light, but Serial Monitor says:

...........................................
Start USBDroid microSD card Test Procedure.
Timestamp 208ms

etc....

so there's actually an SD card test installed!!

Dave

a3rd
Posts: 1
Joined: Mon Apr 06, 2015 4:32 am

Re: New Docs please...

Post by a3rd » Mon Apr 06, 2015 4:40 am

haha you're lucky it might be a freebie.

1. Power down the board.
2. Remove the SD Card
3. Install Arduino IDE from Arduino.cc
4. Install the Freetronics USB driver for windows
5. Plug your USBdroid back in
6. In Arduino IDE, navigate to File > Examples > 1.0 Basics > Blink
7. A new sketch will open up, press "Verify" then "Upload" and your should be blinking.....

BTW - did you buy it new or used? Someone might have had something running on the SD card when you got the device.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest