Terminal shield to suit EtherMega/EtherTen

Do you have an idea for a device that you think Freetronics should create? Discuss your ideas here! Sometimes we may even give you a sneak peek at secret projects we have in the pipeline, or ask for feedback on designs before they go into production.
Post Reply
effgee
Posts: 64
Joined: Tue Aug 07, 2012 2:41 am

Terminal shield to suit EtherMega/EtherTen

Post by effgee » Wed Nov 21, 2012 2:44 pm

so I don't have to hacksaw/butcher out a rectangle above the ethernet port.
Image

Yes I can use another set of headers to get the extra height, but I've been bitten a couple of times with dodgy connections on multi-stacked shields, especially when there is a 'headers for spacing only' layer, since its way looser (not being soldered to a board).

Post Reply