I am attempting to use the Freetronics 16x2 LCD Shield combined with a 12 digit keypad which is using pins 0,1,2,10,11,12,13.
The LCD works fine but have been unsuccessful in getting the keypad to work. I have double and triple checked pin assignments, tried example code with pin assignments. Any suggestions on what to check?
Issues with LCD sheild and 12 digit keypad
The EtherTen combines an Uno-equivalent Arduino-compatible board and Wiznet-based Ethernet support, along with a microSD card slot and Power-over-Ethernet support. [Product page]
Jump to
- Arduino-Compatible Boards
- ↳ ArduPhone
- ↳ CNCPlotter
- ↳ Eleven
- ↳ EtherDue
- ↳ EtherMega
- ↳ EtherTen
- ↳ Goldilocks
- ↳ KitTen
- ↳ LeoStick
- ↳ LeoStick examples, software and fun sketches
- ↳ Pebble v2
- ↳ StepDuino
- ↳ USBDroid
- Arduino Expansion Shields
- ↳ BTSH: Bluetooth Shield
- ↳ DLOCK: RFID Door Lock Shield
- ↳ ES: Ethernet Shield
- ↳ HBRIDGE: H-Bridge Motor Driver Shield
- ↳ LCDK: LCD & Keypad Shield
- ↳ RX315/RX433: 315MHz and 433MHz Receiver Shields
- ↳ SECSENSE: Security Sensor Shield
- ↳ SH-RFIDLOCK: RFID Lock Shield
- ↳ SBS: SimpleBot Shield
- ↳ THINK: Thinker Shield
- ↳ TS: Terminal Shield
- Modules, Sensors, & Displays
- ↳ Module Discussion
- ↳ Dot Matrix Display
- ↳ Experimenters Kit
- ↳ 4x4x4 RGB Cube
- ↳ OLED128 Display
- Raspberry Pi
- ↳ Raspberry Pi Expansion Boards
- ArduSat Arduino Satellite
- ↳ General ArduSat Discussion
- ↳ ArduSat Payload Processor Module
- General Discussion
- ↳ Random Chit-Chat
- ↳ Project Showcase
- ↳ Product / Device Ideas
- ↳ Practical Arduino
- ↳ Arduino Workshop
- ↳ 3D Printing
- ↳ SuperHouseTV Home Automation
- Arduino Shield List
- ↳ Shield Discussion
- ↳ Shield List Site Discussion