Page 1 of 1

Etherten with USB Shield

Posted: Thu Jan 28, 2016 2:41 pm
by erazor123
Hi everyone,

I have a USB shield attched to the Etherten and don't get it working. I use USB HOST SHIELD Libary 2.0 and changed SS Pin in usbcore.h to P6. I tested on Arduino uno and USB shield works fine with rerouted SS Pin. deployed same sketch to Etherten dont work.

Any ideas / experiences?

Re: Etherten with USB Shield

Posted: Thu Jan 28, 2016 8:19 pm
by andrew
Could you please post a link to the shield you are using?

Re: Etherten with USB Shield

Posted: Fri Jan 29, 2016 9:49 am
by erazor123
https://www.arduino.cc/en/Main/ArduinoU ... HostShield[/url]

Its an original shield. Just bend pin 10 and reconnect pin 6 because its internally connected with the wiznet chip i suppose.

Re: Etherten with USB Shield

Posted: Sat Jan 30, 2016 6:00 am
by andrew
There will be conflict as both shields use digital pins 10~13 - EtherTen uses those for the SPI bus (Ethernet controller IC) and your USB shield uses SPI for the USB host controller IC.

Re: Etherten with USB Shield

Posted: Tue May 23, 2017 12:26 pm
by choknanee
connected with the wiznet chip i suppose
จีคลับ