Hi everyone,
I have a USB shield attched to the Etherten and don't get it working. I use USB HOST SHIELD Libary 2.0 and changed SS Pin in usbcore.h to P6. I tested on Arduino uno and USB shield works fine with rerouted SS Pin. deployed same sketch to Etherten dont work.
Any ideas / experiences?
Etherten with USB Shield
Re: Etherten with USB Shield
Could you please post a link to the shield you are using?
Re: Etherten with USB Shield
https://www.arduino.cc/en/Main/ArduinoU ... HostShield[/url]
Its an original shield. Just bend pin 10 and reconnect pin 6 because its internally connected with the wiznet chip i suppose.
Its an original shield. Just bend pin 10 and reconnect pin 6 because its internally connected with the wiznet chip i suppose.
Re: Etherten with USB Shield
There will be conflict as both shields use digital pins 10~13 - EtherTen uses those for the SPI bus (Ethernet controller IC) and your USB shield uses SPI for the USB host controller IC.
Re: Etherten with USB Shield
connected with the wiznet chip i suppose
จีคลับ
จีคลับ