Etherten with USB Shield

The EtherTen combines an Uno-equivalent Arduino-compatible board and Wiznet-based Ethernet support, along with a microSD card slot and Power-over-Ethernet support. [Product page]
Post Reply
User avatar
erazor123
Posts: 2
Joined: Thu Jan 28, 2016 2:36 pm
Location: Germany

Etherten with USB Shield

Post by erazor123 » Thu Jan 28, 2016 2:41 pm

Hi everyone,

I have a USB shield attched to the Etherten and don't get it working. I use USB HOST SHIELD Libary 2.0 and changed SS Pin in usbcore.h to P6. I tested on Arduino uno and USB shield works fine with rerouted SS Pin. deployed same sketch to Etherten dont work.

Any ideas / experiences?

andrew
Freetronics Staff
Freetronics Staff
Posts: 978
Joined: Sun Jul 14, 2013 7:06 am
Location: Melbourne, Australia
Contact:

Re: Etherten with USB Shield

Post by andrew » Thu Jan 28, 2016 8:19 pm

Could you please post a link to the shield you are using?

User avatar
erazor123
Posts: 2
Joined: Thu Jan 28, 2016 2:36 pm
Location: Germany

Re: Etherten with USB Shield

Post by erazor123 » Fri Jan 29, 2016 9:49 am

https://www.arduino.cc/en/Main/ArduinoU ... HostShield[/url]

Its an original shield. Just bend pin 10 and reconnect pin 6 because its internally connected with the wiznet chip i suppose.
Attachments
usb_kl.jpg

andrew
Freetronics Staff
Freetronics Staff
Posts: 978
Joined: Sun Jul 14, 2013 7:06 am
Location: Melbourne, Australia
Contact:

Re: Etherten with USB Shield

Post by andrew » Sat Jan 30, 2016 6:00 am

There will be conflict as both shields use digital pins 10~13 - EtherTen uses those for the SPI bus (Ethernet controller IC) and your USB shield uses SPI for the USB host controller IC.

choknanee
Posts: 2
Joined: Mon Mar 13, 2017 11:21 pm

Re: Etherten with USB Shield

Post by choknanee » Tue May 23, 2017 12:26 pm

connected with the wiznet chip i suppose
จีคลับ

Post Reply