Hi, I am new to arduino ethernet programming. I suspect this is a basis issue i am not trained for. can any one help?
I am testing a freeware using a encoder to check turns based on status change on digital pins. This is working great only for pin2 and 3. But when i change to pins4 and 5 or others it does not work at all. I do no have such issue with the original arduino uno board, however. anyone has experience with this please?
The EtherTen combines an Uno-equivalent Arduino-compatible board and Wiznet-based Ethernet support, along with a microSD card slot and Power-over-Ethernet support. [Product page]
2 posts •Page 1 of 1
- Freetronics Staff
- Joined:Sun Jul 14, 2013 7:06 am
- Location:Melbourne, Australia
Is anything else connected to digital pin 4? If you are using a Freetronics EtherTen or a separate Ethernet shield, the SS pin of the SD card reader is connected to D4. Try other digital pins.