Using a AC to DC Power Supply 1A

The EtherTen combines an Uno-equivalent Arduino-compatible board and Wiznet-based Ethernet support, along with a microSD card slot and Power-over-Ethernet support. [Product page]
Post Reply
EdDziuk
Posts: 1
Joined: Sun Jan 11, 2015 1:16 am

Using a AC to DC Power Supply 1A

Post by EdDziuk » Sun Jan 11, 2015 1:30 am

The Instructables project that I'm using recommends a power supply that provides 7.5V with 300ma for the EtherTen. I have one that outputs 1A. Will that be too much for the board?

andrew
Freetronics Staff
Freetronics Staff
Posts: 978
Joined: Sun Jul 14, 2013 7:06 am
Location: Melbourne, Australia
Contact:

Re: Using a AC to DC Power Supply 1A

Post by andrew » Sun Jan 11, 2015 4:31 am

EdDziuk wrote:The Instructables project that I'm using recommends a power supply that provides 7.5V with 300ma for the EtherTen. I have one that outputs 1A. Will that be too much for the board?
Actually you would need 1A, so that's perfect.
Could you please reply with the link to the Instructable?
Thanks
John

Post Reply