Inductor L3 on schematic

The EtherTen combines an Uno-equivalent Arduino-compatible board and Wiznet-based Ethernet support, along with a microSD card slot and Power-over-Ethernet support. [Product page]
Post Reply
Aliraza852
Posts:1
Joined:Fri Oct 17, 2014 7:20 am
Inductor L3 on schematic

Post by Aliraza852 » Fri Oct 17, 2014 7:30 am

I have been studying the etherten schematic and was stumped about the value for inductor part L3?

Great product design!

_______________
ali

angusgr
Freetronics Staff
Freetronics Staff
Posts:853
Joined:Tue Apr 09, 2013 11:19 pm
Location:Melbourne, Australia
Contact:

Re: Inductor L3 on schematic

Post by angusgr » Sun Oct 19, 2014 8:42 pm

Hi Ali,

I've split your post into a new thread as it wasn't related to the thread you posted in.

L3 is mislabelled on the schematic, I just changed the label to "0805 FERRITE". Almost any ferrite bead with a low DC resistance (ideally <15mOhm) should be fine. We specify one with a DC current rating 2-3A, to keep some headroom.


Angus

Post Reply