Page 1 of 1

Motor Shield for EtherTen

Posted: Sat Jun 28, 2014 5:08 pm
by tim94928
Hi,

Can anyone recommend a motor shield or motor controller that fits the EtherTen well, i.e. doesn't collide with the LAN connector?

Or if none such exists, then please recommend a motor shield or motor controller that works with stacking headers to hoist it over the LAN connector, or whatever you think is the best way to drive small hobby motors with the EtherTen.

Thanks,

Tim

Re: Motor Shield for EtherTen

Posted: Sun Jun 29, 2014 3:20 am
by andrew
You could use our HBRDIGE: motor shield and a set of stacking headers:

http://www.freetronics.com/collections/ ... ver-shield

http://www.freetronics.com/collections/ ... ld-headers

Re: Motor Shield for EtherTen

Posted: Tue Sep 23, 2014 5:37 am
by Razaali1
Yes using that 1 wire library, I might of pop that port. Changed the sensor to one A3 and set A3 to digital and it works fine 8-) . Can confirm the fish tank only drops 0.7C overnight which is great. Thanks for a advice.