Motor Shield for EtherTen

The EtherTen combines an Uno-equivalent Arduino-compatible board and Wiznet-based Ethernet support, along with a microSD card slot and Power-over-Ethernet support. [Product page]
Post Reply
tim94928
Posts:3
Joined:Sun Dec 29, 2013 2:23 pm
Motor Shield for EtherTen

Post by tim94928 » Sat Jun 28, 2014 5:08 pm

Hi,

Can anyone recommend a motor shield or motor controller that fits the EtherTen well, i.e. doesn't collide with the LAN connector?

Or if none such exists, then please recommend a motor shield or motor controller that works with stacking headers to hoist it over the LAN connector, or whatever you think is the best way to drive small hobby motors with the EtherTen.

Thanks,

Tim

andrew
Freetronics Staff
Freetronics Staff
Posts:978
Joined:Sun Jul 14, 2013 7:06 am
Location:Melbourne, Australia
Contact:

Re: Motor Shield for EtherTen

Post by andrew » Sun Jun 29, 2014 3:20 am

You could use our HBRDIGE: motor shield and a set of stacking headers:

http://www.freetronics.com/collections/ ... ver-shield

http://www.freetronics.com/collections/ ... ld-headers

Razaali1
Posts:1
Joined:Tue Sep 23, 2014 5:07 am

Re: Motor Shield for EtherTen

Post by Razaali1 » Tue Sep 23, 2014 5:37 am

Yes using that 1 wire library, I might of pop that port. Changed the sensor to one A3 and set A3 to digital and it works fine 8-) . Can confirm the fish tank only drops 0.7C overnight which is great. Thanks for a advice.

Post Reply