Page 1 of 1

Etherten not recognized anymore?

Posted: Mon Feb 25, 2013 6:05 pm
by NickPatey
My etherten stopped being recognized in the device manager of my computer (no longer listed under comm ports) and i dont know why. When i connect my board to the computer using usb the blue power light comes on but D13 doesnt even flash, not even when i press reset.

I dont think i fried anything, i didnt go under 0V or over 5V for any of my inputs/outputs, so i really dont know what the problem is.

Re: Etherten not recognized anymore?

Posted: Tue Feb 26, 2013 3:15 am
by NickPatey
i have tried a different port, and i know its not the cable, the cable hasnt modes since i bought it.

The only thing i can think of is when it was running a sketch i pulled the cable out then put it back in, after that it wasnt working. Is there any way to reset it or anything?

Re: Etherten not recognized anymore?

Posted: Tue Feb 26, 2013 1:29 pm
by NickPatey
OK i will try a new cable, but it was just monitoring some small analog signals.

Re: Etherten not recognized anymore?

Posted: Tue Feb 26, 2013 5:01 pm
by NickPatey
New cable did nothing, same problem

Re: Etherten not recognized anymore?

Posted: Thu Feb 28, 2013 2:45 pm
by NickPatey
Is there a way to reset the 16u chip like you can the 8u on the arduino?