Page 1 of 1

EtherTen - No MAC Id on Board

Posted: Thu Sep 13, 2012 6:41 am
by txniteowl
Any ideas how I can obtain the MAC address from my board which shipped with no MAC address sticker attached. Any programs out there to read the chip? Help! :( :( :(

Comments.

Thanks for the help previously...issues resolved. :) :) :) :)

Txniteowl

Re: EtherTen - No MAC Id on Board

Posted: Mon Sep 17, 2012 1:13 am
by effgee
from http://www.freetronics.com/pages/ethert ... FZ2n41Dwjw
Note that just like the official Ethernet Shield, the EtherTen does not come with a specifically assigned MAC address stored in hardware. The MAC address must be set from inside your sketch, just as you'll find near the start of each of the Ethernet examples. You can pick any valid MAC address you like as long as it's unique on your network.

Re: EtherTen - No MAC Id on Board

Posted: Wed Sep 19, 2012 10:40 am
by jebz
Most examples use -
byte mac[] = {
0xDE, 0xAD, 0xBE, 0xEF, 0xFE, 0xED};