Page 1 of 1

Upload Sketchvia Network upload no work

Posted: Mon Apr 30, 2018 10:09 am
by selfmade01
Hello
im not sure i find the right section.

i try now thos HowTo
https://www.freetronics.com.au/pages/ho ... ubomKSFO71

i use a arduino nano with a W5100 Mini Ethernet shield.
For burning my EEprom i use a USBasp programmer

i work step by step the Howto and all looks fine
i get only a message
"avrdude: warning: cannot set sck period. please check for usbasp firmware update."
But he burn my now Bootloadfer with Tftp
i get ip-connection to the Ethernet-shield too
i change the Networksettings and i burn the bootloader with tftp new

the testing LED o Pin9 works too

but if i would like upload my new Blink.bin to the arduino over command-line ... thats no work
i use
tftp -i 192.168.2.58 put Blink.bin

i have had before deaktivated my kaspersky firewall too

what i can do?

thanks a lot for any help

Best regards
j├╝rgen