im not sure i find the right section.
i try now thos HowTo
https://www.freetronics.com.au/pages/ho ... ubomKSFO71
i use a arduino nano with a W5100 Mini Ethernet shield.
For burning my EEprom i use a USBasp programmer
i work step by step the Howto and all looks fine
i get only a message
"avrdude: warning: cannot set sck period. please check for usbasp firmware update."
But he burn my now Bootloadfer with Tftp
i get ip-connection to the Ethernet-shield too
i change the Networksettings and i burn the bootloader with tftp new
the testing LED o Pin9 works too
but if i would like upload my new Blink.bin to the arduino over command-line ... thats no work
tftp -i 192.168.2.58 put Blink.bin
i have had before deaktivated my kaspersky firewall too
what i can do?
thanks a lot for any help
The EtherTen combines an Uno-equivalent Arduino-compatible board and Wiznet-based Ethernet support, along with a microSD card slot and Power-over-Ethernet support. [Product page]
1 post • Page 1 of 1