I am attempting to use the Freetronics 16x2 LCD Shield combined with a 12 digit keypad which is using pins 0,1,2,10,11,12,13.
The LCD works fine but have been unsuccessful in getting the keypad to work. I have double and triple checked pin assignments, tried example code with pin assignments. Any suggestions on what to check?
The EtherTen combines an Uno-equivalent Arduino-compatible board and Wiznet-based Ethernet support, along with a microSD card slot and Power-over-Ethernet support. [Product page]
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests