Hi,
I am using an Arduino uno board with the Freetonics door lock shield and a priority one design RFID reader. Will the example code for the shield work with HDX animal tags? If not are they any suggestions for the sketch to get them to read?
RFID door lock shield sketch / HDX animal tags
Control electric door locks and strike plates using your Arduino and an RFID module. Serial interface for an external RFID reader, and a switched output for door strike control. [Product page]
Return to “DLOCK: RFID Door Lock Shield”
Jump to
- Arduino-Compatible Boards
- ↳ ArduPhone
- ↳ CNCPlotter
- ↳ Eleven
- ↳ EtherDue
- ↳ EtherMega
- ↳ EtherTen
- ↳ Goldilocks
- ↳ KitTen
- ↳ LeoStick
- ↳ LeoStick examples, software and fun sketches
- ↳ Pebble v2
- ↳ StepDuino
- ↳ USBDroid
- Arduino Expansion Shields
- ↳ BTSH: Bluetooth Shield
- ↳ DLOCK: RFID Door Lock Shield
- ↳ ES: Ethernet Shield
- ↳ HBRIDGE: H-Bridge Motor Driver Shield
- ↳ LCDK: LCD & Keypad Shield
- ↳ RX315/RX433: 315MHz and 433MHz Receiver Shields
- ↳ SECSENSE: Security Sensor Shield
- ↳ SH-RFIDLOCK: RFID Lock Shield
- ↳ SBS: SimpleBot Shield
- ↳ THINK: Thinker Shield
- ↳ TS: Terminal Shield
- Modules, Sensors, & Displays
- ↳ Module Discussion
- ↳ Dot Matrix Display
- ↳ Experimenters Kit
- ↳ 4x4x4 RGB Cube
- ↳ OLED128 Display
- Raspberry Pi
- ↳ Raspberry Pi Expansion Boards
- ArduSat Arduino Satellite
- ↳ General ArduSat Discussion
- ↳ ArduSat Payload Processor Module
- General Discussion
- ↳ Random Chit-Chat
- ↳ Project Showcase
- ↳ Product / Device Ideas
- ↳ Practical Arduino
- ↳ Arduino Workshop
- ↳ 3D Printing
- ↳ SuperHouseTV Home Automation
- Arduino Shield List
- ↳ Shield Discussion
- ↳ Shield List Site Discussion