RFID DOOR LOCK Shield eletric Strike

Control electric door locks and strike plates using your Arduino and an RFID module. Serial interface for an external RFID reader, and a switched output for door strike control. [Product page]
Post Reply
hanish
Posts: 6
Joined: Fri Feb 06, 2015 4:05 am

RFID DOOR LOCK Shield eletric Strike

Post by hanish » Mon Mar 30, 2015 11:37 am

Hello, does anyone have a diagram of how should i wire an electric strike plate to the RFID Door lock shield? ( http://www.freetronics.com.au/products/ ... Rk0-47qU9d).

Also, should the 12V input go though a resistor first? if yes, which one?

Thankss :mrgreen: :mrgreen: ..

Regards
Hanish
Top
andrew
Freetronics Staff
Freetronics Staff
Posts: 978
Joined: Sun Jul 14, 2013 7:06 am
Location: Melbourne, Australia
Contact:
Contact andrew

Re: RFID DOOR LOCK Shield eletric Strike

Post by andrew » Mon Mar 30, 2015 9:15 pm

Please see:
http://www.freetronics.com.au/pages/rfi ... tart-guide

Strike plate connects to the strike plate output terminals, 12V in to the 12V input terminals. If you have a regulated 12V supply there's no need to put a resistor in.
Top
Post Reply

Return to “DLOCK: RFID Door Lock Shield”