Speed control isn't working

Drive a 4-wire bipolar stepper motor or a pair of DC motors from your Arduino. [Product page]
Post Reply
Posts: 1
Joined: Wed Mar 15, 2017 4:33 am

Speed control isn't working

Post by amacmelb » Wed Mar 15, 2017 4:35 am

Could be a very dumb question,

However when im controlling the speed of the motor, input from 255 to 1 has no effect on the motor. it seems like the motor continues to spin at full speed however, when i send a 0 for speed. it will stop immediately.

Please help.


Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest