Is there any reason the H-Bridge couldn't be used as a 4 channel 'relay', to drive only one output at a time (with the added benefit of voltage level control)?
I would like to control 4 different valves, but only one of them at a time. They all have a common ground, so I thought this would be a good way to control the input voltage.
Thoughts?
H-Bridge as a 4 channel relay?
-
- Freetronics Staff
- Posts: 978
- Joined: Sun Jul 14, 2013 7:06 am
- Location: Melbourne, Australia
- Contact:
Re: H-Bridge as a 4 channel relay?
Not by design, the output pairs are either +/- or -/+ or off.