using this shield with 3.3v arduino's

Drive a 4-wire bipolar stepper motor or a pair of DC motors from your Arduino. [Product page]
Post Reply
Mick
Posts: 2
Joined: Sat Nov 09, 2013 11:57 pm

using this shield with 3.3v arduino's

Post by Mick » Sat Jan 30, 2016 1:01 am

hi

i may be wrong but this shield should work fine as its all outputs that are used so no 5v should be going back into the due's inputs but i just wanted to confirm this save me killing my due
Top
andrew
Freetronics Staff
Freetronics Staff
Posts: 978
Joined: Sun Jul 14, 2013 7:06 am
Location: Melbourne, Australia
Contact:
Contact andrew

Re: using this shield with 3.3v arduino's

Post by andrew » Sat Jan 30, 2016 6:07 am

Yes, you're fine with the Due.
Top
Post Reply

Return to “HBRIDGE: H-Bridge Motor Driver Shield”