Hbridge with bt shield and eleven

Drive a 4-wire bipolar stepper motor or a pair of DC motors from your Arduino. [Product page]
Post Reply
Boggy
Posts: 1
Joined: Sun May 17, 2015 10:22 am

Hbridge with bt shield and eleven

Post by Boggy » Sun May 17, 2015 10:34 am

Do you have any thoughts on how to re configure the pins to avoid conflicts.
At the moment when the bt is active motor fires up.

andrew
Freetronics Staff
Freetronics Staff
Posts: 978
Joined: Sun Jul 14, 2013 7:06 am
Location: Melbourne, Australia
Contact:

Re: Hbridge with bt shield and eleven

Post by andrew » Sun May 17, 2015 10:37 pm

You could run jumper wires from the BT TX/RX rows to digital pins not used by the motor shield - such as D8/D9, or solder them for a more permanent use.

Post Reply