Page 1 of 1

Wiring to Bluz

Posted: Thu Oct 06, 2016 5:31 pm
by DeveloperITA
Hi everyone!
I'm going to buy this OLED screen, but I need to use it with Bluz (a modified version of Particle Photon). In the getting start guide there are only instructions to connect it to the ICSP port. I know this is the same thing of connecting it to normal PINs. Which one should I use? Hope you understanf me, thank you.

Re: Wiring to Bluz

Posted: Sat Oct 08, 2016 9:20 am
by DeveloperITA
No one has an idea? Please help me D:

Re: Wiring to Bluz

Posted: Sun Oct 09, 2016 11:17 am
by nickwest
I think I understand what you mean - using the ICSP port is the same as wiring to PINs.

The ICSP port on Arduinos is connected directly to the normal pins on the Arduino and they share the SPI bus. Have a look at the schematic at https://www.arduino.cc/en/uploads/Main/ ... ematic.pdf to show you the correct pins to use.