Wiring to Bluz

128x128 pixel 1.5" full colour OLED display with MicroSD card slot. [Product page]
Post Reply
DeveloperITA
Posts: 2
Joined: Thu Oct 06, 2016 5:28 pm

Wiring to Bluz

Post by DeveloperITA » Thu Oct 06, 2016 5:31 pm

Hi everyone!
I'm going to buy this OLED screen, but I need to use it with Bluz (a modified version of Particle Photon). In the getting start guide there are only instructions to connect it to the ICSP port. I know this is the same thing of connecting it to normal PINs. Which one should I use? Hope you understanf me, thank you.

DeveloperITA
Posts: 2
Joined: Thu Oct 06, 2016 5:28 pm

Re: Wiring to Bluz

Post by DeveloperITA » Sat Oct 08, 2016 9:20 am

No one has an idea? Please help me D:

nickwest
Posts: 8
Joined: Sun Oct 28, 2012 10:20 pm

Re: Wiring to Bluz

Post by nickwest » Sun Oct 09, 2016 11:17 am

I think I understand what you mean - using the ICSP port is the same as wiring to PINs.

The ICSP port on Arduinos is connected directly to the normal pins on the Arduino and they share the SPI bus. Have a look at the schematic at https://www.arduino.cc/en/uploads/Main/ ... ematic.pdf to show you the correct pins to use.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests