Page 1 of 1

FTOLED and Sanguinololu

Posted: Sat Feb 24, 2018 2:42 am
by Jez_A

I have a RepRap Prusa Mendel 3D printer, being controller via a Sanguinololu ... u48479PcJR control board. I am wondering if anyone has managed to connect the Freetronics OLED screen to this board (using the Marlin v1.1.8 Firmware) and the expansion pins on the lower right of the board ( ... to-top.jpg?

If so, what are the pins used and the marlin firmware changes needed to drive the screen?

I understand from digging in to the Marlin firmware that controller screens are driven using the u8glib arduino library, which has support for the FTOLED display. I am just not able to determine the firmware changes needed and the pins to use to drive this screen.

Any information would be greatly appreciated. Thanks..