Software debugging and blink

barjammar · Post by **barjammar** » Mon Apr 03, 2017 3:20 pm

Hi, I had a deaf and dumb cube for a while! I put it together three years ago and it worked fine but that windows laptop I used then is now scrapped and I am trying to run the cube on a MacBook pro. I have the IDE installed and can run other Arduino boards on it se the hardware is OK.

After some playing around I now have it flashing all the led's in a test pattern.

But I need a stepwise setup for the cube to reload the software into it.
What board is it? (set Leo Stick after adding those hardware files to sketch: /hardware/ directory)
What baud rate (set 9600)
Do i need libraries added in?

The information is spread around the net and it would help if I could see a youtube of the actual software setup.
Does anyone have that? I'm concerned that my drivers or firmware etc. might be old and need replacing.
Gracias