Hi, I had a deaf and dumb cube for a while! I put it together three years ago and it worked fine but that windows laptop I used then is now scrapped and I am trying to run the cube on a MacBook pro. I have the IDE installed and can run other Arduino boards on it se the hardware is OK.
After some playing around I now have it flashing all the led's in a test pattern.
But I need a stepwise setup for the cube to reload the software into it.
What board is it? (set Leo Stick after adding those hardware files to sketch: /hardware/ directory)
What baud rate (set 9600)
Do i need libraries added in?
The information is spread around the net and it would help if I could see a youtube of the actual software setup.
Does anyone have that? I'm concerned that my drivers or firmware etc. might be old and need replacing.
The "Cube4" is a 4x4x4 RGB LED cube with an Arduino Leonardo compatible onboard controller. [Product page]
1 post • Page 1 of 1