Hi Team,
I am playing around with my cube, and now I want to make the cube invaders. I have gone and gotten myself a wii Chuck, and downloaded the library. Now how do I go about connecting the chuck to the cube? I was thinking of buying some wiichuck shields, but if anyone has a better way I would love to hear it.
Cube Invaders
-
- Posts: 2
- Joined: Fri Mar 10, 2017 10:09 am
- Location: Australia
- Contact:
-
- Posts: 2
- Joined: Fri Mar 10, 2017 10:09 am
- Location: Australia
- Contact:
Re: Cube Invaders
Well its all in the documentation. FYI for anyone else who doesn't know, you need to install two pullup resistors around 4k7 ohm, and then the Yellow wiichuck cable goes to SCL, Green goes to SDA, White goes to GND and Red to VCC. This is on the comms input section of the board.