Page 1 of 1

FreeTronics 4x4x4 no response - upload fine

Posted: Tue Dec 18, 2018 5:54 pm
by cowboybilliards
Hi,

Here is the setup I currently have. I have gotten past the Error 1 issue.


The following is under a directory called Arduino:

Under a Folder in ARDUINO, I have

cube4 > cube4 - master

hardware > FreeTronix USB Drivers

Leonardo Drivers

LeoStickBoardProfile-master



Is this correct? What am I missing....I am running win 10 and went back from IDE 1.8.8 to 1.0.6 thinking IDE is not backward compatible.....


I seem to be able to upload as the Verify/Upload comes out clean, but I only get rapid blue light, some movement of the LEDs: a slight flash, and that is it....

Any ideas?

Thanks,

Leo

P.S. did not see a related post.