Software debugging and blink

The "Cube4" is a 4x4x4 RGB LED cube with an Arduino Leonardo compatible onboard controller. [Product page]
Post Reply
barjammar
Posts: 2
Joined: Sun Sep 08, 2013 9:26 am

Software debugging and blink

Post by barjammar » Mon Apr 03, 2017 3:20 pm

Hi, I had a deaf and dumb cube for a while! I put it together three years ago and it worked fine but that windows laptop I used then is now scrapped and I am trying to run the cube on a MacBook pro. I have the IDE installed and can run other Arduino boards on it se the hardware is OK.

After some playing around I now have it flashing all the led's in a test pattern.

But I need a stepwise setup for the cube to reload the software into it.
What board is it? (set Leo Stick after adding those hardware files to sketch: /hardware/ directory)
What baud rate (set 9600)
Do i need libraries added in?

The information is spread around the net and it would help if I could see a youtube of the actual software setup.
Does anyone have that? I'm concerned that my drivers or firmware etc. might be old and need replacing.
Gracias

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests