Page 1 of 1

Servo wires

Posted: Wed Sep 10, 2014 11:40 am
by kellyw
Hi,

Just bought a new Experimenters Kit.
According to project guide, Servo for project 6 should have 3 separate wires which are to connected to GND, 5V and D11. But the Servo provided with my kit has 3 connected wires with single 3 pin female connector. How do I connect this to the Arduino?

Cheers Wayne.

Re: Servo wires

Posted: Wed Sep 10, 2014 10:23 pm
by angusgr
Hi Wayne,

You can use the male-to-male breadboard wires with the servo socket. If you insert a wire into each of the 3 female connections on the servo, you can then run the other ends to the female connections on the Eleven.

Regards,


Angus