Page 1 of 1

What are the holes for?

Posted: Sat Oct 14, 2017 7:22 am
by Vagulus
I was always told that the only stupid question is the one you don't ask, so I feel safe asking this one.

On the Freetronics "Eleven" there is an area of holes at breadboard spacing. Are they there purely as convenient places to solder in ICs or whatever, or is there a more sinister purpose? 8-)

Re: What are the holes for?

Posted: Fri Apr 13, 2018 12:17 am
by jonoxer
It's a mini prototyping area, like what you get with a separate prototyping shield but directly integrated into the main board. You can use it to add parts to the Eleven that you want to be permanently connected, like if you're building the board into a project and want to make it low profile.

John Boxall from TronixLabs / TronixStuff has a great article here showing how he used it to put an RTC on an Eleven:

http://tronixstuff.com/2010/10/07/add-a ... twentyten/

I've tried to fit some prototyping space on our Arduino compatible boards whereever possible. Even the EtherMega has a small spot that doesn't look like it would be big enough to be useful, but I've used that myself a few times. On the old EtherMega I used to install a MAC address chip in that space, but in the current EtherMega I incorporated the MAC chip straight into the design. I've also used it to put a watchdog timer on the board.

Re: What are the holes for?

Posted: Tue May 15, 2018 7:25 am
by Vagulus
Sorry about the much belated reply but ... thanks for that. I am not sure I grasp the advantages of putting other ICs on the board, but that's 'cos I'm just a beginner.

Cheers