I loving the Eleven.
I got the experimenter's kit and am making good progress on being able to control 8 LEDs with a shift register and also a servo in preparation for applying the project to a doll house.
My sketch operates as I plan but when I plug in the USB for the first time, the LED's flash for an instant and the servo jitters a little. After that instant (far less than a second), the board and the sketch operates as I plan.
I have read that this might be that there is current leak to the outputs while the bootloader runs/starts before it gets to my program.
Is this a problem or just how it works?
Can it be fixed through, as I have read, placing a "pull down resitor" (eg 7K) somewhere.
I can post an image and a diagram if it would assist.
The "Eleven" is our Uno-equivalent Arduino-compatible board, but with a number of improvements including prototyping area, a mini-USB connector, LEDs mounted near the edge, and the D13 LED isolated using a FET. [Product page]
1 post •Page 1 of 1