Problem Uploading to Board

The "Eleven" is our Uno-equivalent Arduino-compatible board, but with a number of improvements including prototyping area, a mini-USB connector, LEDs mounted near the edge, and the D13 LED isolated using a FET. [Product page]
Post Reply
Philoslothical
Posts: 1
Joined: Sat Dec 24, 2016 1:07 am

Problem Uploading to Board

Post by Philoslothical » Sat Dec 24, 2016 1:10 am

Hi, I have a had an Freetronics Eleven for a while now and I havent been able to get the sketches to upload to the board, I have tried searching on the internet for solutions and also on the Arduino forums. The following is the error messages i have been getting.

Arduino: 1.6.8 (Windows 7), Board: "Arduino/Genuino Uno"

Sketch uses 1,166 bytes (3%) of program storage space. Maximum is 32,256 bytes.
Global variables use 9 bytes (0%) of dynamic memory, leaving 2,039 bytes for local variables. Maximum is 2,048 bytes.
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x00
Problem uploading to board. See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.

Post Reply