3 wire inductive sensor and LeoStick

A shrunk down Leonardo-compatible board, thumb drive sized with native USB support. [Product info]
Post Reply
alind
Posts: 1
Joined: Thu Feb 11, 2016 9:29 am

3 wire inductive sensor and LeoStick

Post by alind » Thu Feb 11, 2016 9:51 am

Step 1:
Parts list:
- Arduino (or any compatible board; I am using an LeoStick for this project)
- 3 wire inductive metal sensor ( I am using an Contrinex DW-AD-403-M5E 10-30 VDC 200mA PNP)
- External power supply 10-30 VDC for sensor
- LED (optional; I am using only for extra indication that sensor is working when activated)
- Wires
- Voltage divider from 12V to 5V (made from one 15k and one 10k resistors)

Step 2
Prepare voltage divider as follow:
- Solder 15k and 10k resistors together.
- Solder an wire same place where you solder the two resistors
Work principle: 15k resistor free end will be input from sensor, 10k resistor free end will be ground connected to Arduino GND pin and external power supply GND; middle wire will be output to Arduino digital input pin (D2 in my case)

Step 3
- Connect sensor positive cable (brown in my case) to 10-30 V power supply
- Connect sensor negative cable (blue in my case) to power supply ground
- Connect sensor data cable (black in my case) to 15k free end of voltage divider.

Step 4 (optional)
- Connect LED positive terminal to middle voltage divider wire
- Connect negative terminal to ground
In my case I've been using same external power supply for this LED due to extra 5V output.

Step 5
- Upload code to Arduino

Code: Select all

/* DigitalReadSerial
 Reads a digital input on pin 2, prints the result to the serial monitor/serial plotter
 This example code is in the public domain.
 */
// digital pin 2 has a PNP sensor attached to it. 
int metalSensor = 2;
// the setup routine runs once when you press reset:
void setup() {
  // initialize serial communication at 9600 bits per second:
  Serial.begin(9600);
  // make the sensor's pin an input:
  pinMode(metalSensor, INPUT);
}
// the loop routine runs over and over again forever:
void loop() {
  // read the input pin:
  int sensorState = digitalRead(metalSensor);
  // print out the state of the sensor:
  Serial.println(sensorState);
  delay(1000);        // delay in between reads for stability
}

angusgr
Freetronics Staff
Freetronics Staff
Posts: 853
Joined: Tue Apr 09, 2013 11:19 pm
Location: Melbourne, Australia
Contact:

Re: 3 wire inductive sensor and LeoStick

Post by angusgr » Mon Feb 15, 2016 3:38 am

Thanks for posting the steps to this! I added some

Code: Select all

 tags around the code block so it was easier to read in the forum post.
 
 Do you have any photos of your setup that might help people reproduce it?
 
 
 Angus

Post Reply