Freetronics Forum

Posted: **Fri Apr 13, 2012 4:08 am**

There is a remarkably parallel conversation going in in the adjacent forum topic, about isolating D11 to allow knock detection with the Piezo!

Check out this very helpful post by @geekscape:

viewtopic.php?f=27&t=300#p1042

Just do what Andy suggests there, but instead of jumpering to an analog input for knock detection (as he suggests) jumper to a PWM output.
--
Jon

Posted: **Fri Apr 13, 2012 4:34 am**

Great, thank you!
I wasn't sure if that other advice would still apply if the Piezo was being written to from another pin instead of being read from.
Loving the LeoStick!

Posted: **Wed May 08, 2013 5:11 am**

I'm so confused.

The Leostick PWM pins are

Posted: **Thu May 09, 2013 1:52 am**

I can only get
3,5,9,10
to output PWM

using the Fade Sketch on the IDE and changing the pin.

any ideas?

Freetronics Forum

Which ports can do PWM?

Re: Which ports can do PWM?

Re: Which ports can do PWM?

Re: Which ports can do PWM?

Re: Which ports can do PWM?