Hi
I'm currently in the process of making a pinball. I have a arduino uno and looking at using this with the DMD for scoring. I was wondering if anyone could help me with codes for.
When the switch is hit by the ball to send it to the DMD
Also adding the scores up.
Any help would be greatly appreciated. I'm sorry this may seem basic to many of you.
Thanks again
Pinball switch to show values on DMD
The Dot Matrix Display (DMD) is a 32x16 array of high-brightness LEDs for visually striking effects. [Product Page]
Return to “Dot Matrix Display”
Jump to
- Arduino-Compatible Boards
- ↳ ArduPhone
- ↳ CNCPlotter
- ↳ Eleven
- ↳ EtherDue
- ↳ EtherMega
- ↳ EtherTen
- ↳ Goldilocks
- ↳ KitTen
- ↳ LeoStick
- ↳ LeoStick examples, software and fun sketches
- ↳ Pebble v2
- ↳ StepDuino
- ↳ USBDroid
- Arduino Expansion Shields
- ↳ BTSH: Bluetooth Shield
- ↳ DLOCK: RFID Door Lock Shield
- ↳ ES: Ethernet Shield
- ↳ HBRIDGE: H-Bridge Motor Driver Shield
- ↳ LCDK: LCD & Keypad Shield
- ↳ RX315/RX433: 315MHz and 433MHz Receiver Shields
- ↳ SECSENSE: Security Sensor Shield
- ↳ SH-RFIDLOCK: RFID Lock Shield
- ↳ SBS: SimpleBot Shield
- ↳ THINK: Thinker Shield
- ↳ TS: Terminal Shield
- Modules, Sensors, & Displays
- ↳ Module Discussion
- ↳ Dot Matrix Display
- ↳ Experimenters Kit
- ↳ 4x4x4 RGB Cube
- ↳ OLED128 Display
- Raspberry Pi
- ↳ Raspberry Pi Expansion Boards
- ArduSat Arduino Satellite
- ↳ General ArduSat Discussion
- ↳ ArduSat Payload Processor Module
- General Discussion
- ↳ Random Chit-Chat
- ↳ Project Showcase
- ↳ Product / Device Ideas
- ↳ Practical Arduino
- ↳ Arduino Workshop
- ↳ 3D Printing
- ↳ SuperHouseTV Home Automation
- Arduino Shield List
- ↳ Shield Discussion
- ↳ Shield List Site Discussion