Mechanical Specs for the DMD?

The Dot Matrix Display (DMD) is a 32x16 array of high-brightness LEDs for visually striking effects. [Product Page]
Post Reply
Brissieboy
Posts:209
Joined:Fri Sep 20, 2013 7:25 am
Mechanical Specs for the DMD?

Post by Brissieboy » Wed Jun 18, 2014 6:41 am

Question for Freetronics:

Are there any specs available for the physical dimensions of the DMD? Not just basic length x breadth etc as shown on the item web page, or simple measurements with a ruler.

I am particularly interested in the positions and spacings of the mounting bolts (and tolerances).

I want to be able to mount 2 units side-by-side with minimal gap, and know that the next pair will fit the same mounting frame pattern.

I have several versions and they differ slightly, only by about a millimetre or so, but enough to make documenting a mounting frame rather awkward. I don't want to have to tailor make each one.

andrew
Freetronics Staff
Freetronics Staff
Posts:978
Joined:Sun Jul 14, 2013 7:06 am
Location:Melbourne, Australia
Contact:

Re: Mechanical Specs for the DMD?

Post by andrew » Wed Jun 18, 2014 11:38 pm

The DMD's physical specifications will vary slightly depending on the colour and build run.

Brissieboy
Posts:209
Joined:Fri Sep 20, 2013 7:25 am

Re: Mechanical Specs for the DMD?

Post by Brissieboy » Thu Jun 19, 2014 7:05 am

Thanks John, but I had already discovered that much. I was hoping for a little more. Ah well, I guess I have to live with it.

Post Reply