need help..ask about pins of DMD

The Dot Matrix Display (DMD) is a 32x16 array of high-brightness LEDs for visually striking effects. [Product Page]
Post Reply
mahfudzaji
Posts:1
Joined:Wed May 28, 2014 1:50 am
need help..ask about pins of DMD

Post by mahfudzaji » Wed May 28, 2014 2:01 am

hi everyone..
I want to use a dot matrix display that can controlled by arduino uno. but something that I dont know is about pins of dot matrix..its like not usual pins name
in that dot matrix, they name it as OE,N,A,B,F,S,L,R..
I just want to know the function of each pin and what I should do to connecting the display to arduino?
thankyou for help :)

angusgr
Freetronics Staff
Freetronics Staff
Posts:853
Joined:Tue Apr 09, 2013 11:19 pm
Location:Melbourne, Australia
Contact:

Re: need help..ask about pins of DMD

Post by angusgr » Wed May 28, 2014 3:04 am

Is this one of our DMD units? Our DMDs use a similar pin naming scheme but not quite the same as that. If it's different hardware then it's probably a different interface.

Post Reply