I have just received a striker plate for my RFID lock setup and I've had a great time getting it all working with the RFID shield.
I noticed on the shield are two small points marked 'release' but with no mention of it in the project files at all. Is this a manual override release for the door lock?
Release
The RFID Lock Shield makes it easy to control an electric door strike using an Arduino and an RFID reader. (Note: obsolete, replaced by the RFID Door Lock Shield). [Product page]
Return to “SH-RFIDLOCK: RFID Lock Shield”
Jump to
- Arduino-Compatible Boards
- ↳ ArduPhone
- ↳ CNCPlotter
- ↳ Eleven
- ↳ EtherDue
- ↳ EtherMega
- ↳ EtherTen
- ↳ Goldilocks
- ↳ KitTen
- ↳ LeoStick
- ↳ LeoStick examples, software and fun sketches
- ↳ Pebble v2
- ↳ StepDuino
- ↳ USBDroid
- Arduino Expansion Shields
- ↳ BTSH: Bluetooth Shield
- ↳ DLOCK: RFID Door Lock Shield
- ↳ ES: Ethernet Shield
- ↳ HBRIDGE: H-Bridge Motor Driver Shield
- ↳ LCDK: LCD & Keypad Shield
- ↳ RX315/RX433: 315MHz and 433MHz Receiver Shields
- ↳ SECSENSE: Security Sensor Shield
- ↳ SH-RFIDLOCK: RFID Lock Shield
- ↳ SBS: SimpleBot Shield
- ↳ THINK: Thinker Shield
- ↳ TS: Terminal Shield
- Modules, Sensors, & Displays
- ↳ Module Discussion
- ↳ Dot Matrix Display
- ↳ Experimenters Kit
- ↳ 4x4x4 RGB Cube
- ↳ OLED128 Display
- Raspberry Pi
- ↳ Raspberry Pi Expansion Boards
- ArduSat Arduino Satellite
- ↳ General ArduSat Discussion
- ↳ ArduSat Payload Processor Module
- General Discussion
- ↳ Random Chit-Chat
- ↳ Project Showcase
- ↳ Product / Device Ideas
- ↳ Practical Arduino
- ↳ Arduino Workshop
- ↳ 3D Printing
- ↳ SuperHouseTV Home Automation
- Arduino Shield List
- ↳ Shield Discussion
- ↳ Shield List Site Discussion