Stacking Shields

Got comments, questions, or tips about any of the shields listed on ShieldList.org? Post them here!
Post Reply
AndrewTurnerAUS
Posts: 3
Joined: Sat Aug 30, 2014 1:09 pm

Stacking Shields

Post by AndrewTurnerAUS » Sat Aug 30, 2014 1:16 pm

Hello,

I have a EtherTen Board and was wondering if I need to make any modification's to stack a H-Bridge motor shield then a 8 channel relay board on top of each other. Please forgive the newbie question but I couldn't find anything in the documentation and just wanted to be sure I didn't damage anything on the boards before proceeding.

angusgr
Freetronics Staff
Freetronics Staff
Posts: 853
Joined: Tue Apr 09, 2013 11:19 pm
Location: Melbourne, Australia
Contact:

Re: Stacking Shields

Post by angusgr » Mon Sep 01, 2014 12:46 am

Hi Andrew,

Yes, this is fine. You probably want to stack the HBridge (which has connections on top) on top of the relay driver (which has connections on the "wing" at the side).

The relay driver uses the i2c pins SDA/SCL, and the HBridge uses all digital pins. So there are no pin conflicts to worry about.


Angus

Post Reply